Learning - SOMFY FX24 Manual De Instalación

To add a Telis type remote control:
[1] Press the "PROG" button on the controller
for two seconds. The red indicator comes on.
[2] Within two minutes of starting the process,
press the "PROG" button on the backside of
the Telis remote control. The red indicator
blinks.
The remote control is paired.
To exit the programming mode without pairing a remote control: Briefl y press the "PROG" button on the controller.
Before starting up, check the electrical connections and the direction of motor rotation.
Position the gate half open.
When the button is pressed for the fi rst time, the gate should open. If not, reverse the connections to the
electric motors.

Learning

Learning the gate's travel distance is a necessary step when setting the motor drive system into service.
During learning, the obstacle detection function is disabled. Remove all objects or obstacles and keep
people from approaching or placing themselves within the motor drive system's operating radius.
To perform an emergency stop during learning, use a paired remote control.
Before starting learning, move the gate by hand to place it in the closed position.
Re-engaging the motor drive system
[1] Lift the lock cover.
[2] Insert the release key and turn it counter clockwise by 90°.
[3] Check gate motion and the action of the limiting devices.
The "Suc" message is displayed showing that the operation has been performed correctly. If the operation is performed
in any other way, the "nSuc" error message is displayed and the operation is not performed.
8
Copyright © 2008 Somfy SAS. All rights reserved.