SOMFY FX24 Manual De Instalación página 11

Start learning
Learning comprises two cycles
(one cycle = one opening + closing operation).
The fi rst cycle is performed without slowing down
and lets the motor memorize full gate travel.
The second cycle with slowing down is intended
to set the minimum amount of torque required to
move the gate.
[1] Press the "OK" button on the controller twice
to access the menus.
[2] Use the "+" and "-" buttons on the controller
to call up the AutoSet menu.
[3] Press the "OK" button to validate. Learning
is started. The gate must perform two
complete cycles.
If learning is completed correctly, the motor
drive system display shows OK.
If learning fails, the motor drive system
display shows KO.
Check the following points before restarting the learning function:
• the gate moves correctly.
• there are no obstacles in front of the photoelectric cells.
If learning is interrupted, return the gate to its closed position and restart learning.
If the slowing down speed is changed later on, a new learning cycle is required.
If a change in settings is performed after learning, make sure that the installation complies with
applicable standards.
AT THIS STAGE IN THE INSTALLATION PROCESS, THE MOTOR DRIVE SYSTEM IS READY TO OPERATE.
Copyright © 2008 Somfy SAS. All rights reserved.
9