Bose A20 Guia Del Usuario página 33

AUX audio source
Problem What to do
No audio from • On the AUX source, turn the volume up.
AUX source
• Make sure the 3.5 mm AUX audio cable is firmly connected to the
• On the control module, make sure the Secondary Audio Mode
• If the Secondary Audio Mode selector is set to MUTE, all
• If you are on an active Bluetooth phone call, you will not hear audio
• Try another AUX source.
Audio in one ear • Make sure the 3.5 mm AUX audio cable is firmly connected to the
only from the AUX
source
• On the headset, make sure the terminator cover is in place and
Cannot hear • Make sure the headset is firmly connected to the intercom/radio
intercom
communications
• Make sure the 3.5 mm AUX audio cable is firmly connected to the
while listening to
audio from AUX
source
AUX source does • Inside battery compartment, check the Priority (BT-AUX) switch.
not mute with
incoming intercom
• If the Secondary Audio Mode selector is set to MIX, all secondary
communications
Cannot be heard • The headset does not support microphone operation when
on a phone call
control module and the AUX source.
selector is in the MUTE or MIX position.
secondary audio sources are temporarily muted when an intercom
signal is detected. Secondary audio will return after intercom audio
ceases.
from the AUX source. AUX audio will resume after the phone call
ends.
control module and the AUX source.
properly connected. Refer to "Attaching the microphone assembly"
on page 10.
system.
control module and the AUX source.
See "The operation switches" on pages 11-12.
audio sources are heard as mixed with the intercom audio. To mute
the AUX source, set the switch to MUTE or OFF.
connected to a device via the AUX audio cable. Hold the device
closer to your mouth to use the device's mic. Or, try connecting the
phone via a Bluetooth connection.
Troubleshooting
English - 33