Truper SME-10 Instructivo página 23

Mounting
A
C
D
F
G
H
I
B
E
Spacer and Disc Guard
• The disc guard is factory-mounted in the spacer. To
simplify the mounting explanation of the spacer mounting
(A) lthe guard is not shown in the image.
• Before mounting or adjusting the spacer, adjust the
cutting disc into the highest position, into a 0° angle and
tighten the cutting angle blocking knob (see page 8). Turn
off and disconnect the saw.
• Screw manually the "L" shape piece (B) to the support
(C) with two sets of screw and star washer as indicated in
the illustration.
• Screw manually the support to the saw work table with
the screw 2".
• Set a ruler against the disc to assure the support and the
"L" shape piece are perfectly aligned to the disc before
tightening (D).
• Screw the spacer to the "L" shape piece with two sets of
screws, star washer and nut. It shall be aligned to the disc
and just behind it.
• Using a universal angle, verify the spacer is 90° with
regards to the work table surface (E) and with the ruler,
verify it is aligned to the disc and just behind it before
screwing all the screws.
• Verify the guard operates correctly. Lift, the guard
manually around 4" and release it (F). The elevation
should feel soft and with no pauses, and when releasing
the guard, it shall return to the work bench immediately.
Tilt the disc 45° and return it to 0° (see page 8) to verify
the spacer is aligned to the disc at all times and the guard
is covering the disc every time. In the event one or both
points described do not happen, correct the mounting
before operating the saw. Remember that the spacer and
guard are the main safety systems in the machine. They
protect you from severe injuries.
Sawing Guide
• Remove the shipping nut and assemble the sawing guide
control as indicated in the figure.
• Slide the sawing guide in the right-hand side of the work
table surface.
• Keep the parallel guide always aligned with the miter
guide mounting slots, otherwise, you are exposed to
kickback. Use a set square to verify alignment.
• To fix the sawing guide in the desired place, tighten the
guide control turning it to the right while putting pressure
on the guide in place to prevent it to move. To release the
guide, turn the control to the left.
• If the guide sits too loose or is difficult to adjust or align,
loosen the two upper screws (G), make the necessary
adjustments and tighten the screws back.
• To mark the distance marked in the guide visor (H), fix
the sawing guide in its place and measure the distance
between the disc face and the guide. This distance shall be
the same indicated in the visor, otherwise, loosen the
indicator (I) screw to set it into the correct measure.
tighten the screw back.
7
ENGLISH