Safety Warnings For Power Saws - Truper SME-10 Instructivo

Safety Warnings
for Power Saws
Before Operating the Saw
CAUTION • Obtain training from a qualified
person, familiar with the equipment and its functioning.
• Do not use the equipment if having trouble to carry out
any operation. Contact immediately the supervisor,
instructor or service center.
• Before connecting and disconnecting the equipment, set
the power plug OFF. (See page 10, section Turning ON).
CAUTION • Verify the cutting disc is duly secured
before starting the equipment.
• Double check the disc is sharp, in good repair, perfectly
aligned, free of rust and tar.
• Before turning on the equipment, verify the cutting disc is
not making contact with the work piece.
• All the machine parts shall be correctly installed.
While Operating the Saw
WARNING
• Always keep your hands away from the
cutting disc.
WARNING • Do not carry out any operation with
your unsupported hands. Use the sawing guide and the
miter guide as indicated in this instructions manual. When
cutting small pieces always use the pushers or pushing
blocks (A) to prevent operating the saw with the hands
close to the disc in motion. To make them, see page 14.
CAUTION • The feeding direction of the work piece
shall always be against the disc teeth and using a constant
and moderate speed.
• The pieces to work with shall always be flat. Never use
warped or twisted wood or round shaped.
WARNING • Avoid awkward stances and
movements which could make your hands and body move
towards the rotating disc.
• Turn it OFF and wait the cutting disc to stop completely
before removing the pieces remaining on the table.
• When a work piece need more than one cut, turn of the
equipment and wait for the cutting disc to stop completely
before setting the piece back for the next cuts.
• When carrying out cuts in an angle, use the help or the
miter guide and remove the sawing guide out of the work
piece trajectory.
Pushing block
(Not included)
Pusher
(Not included)
A
Handle
Kickback
• Prevent from getting a kickback (when the work piece is
shot against the operator). Keep the disc perfectly sharp, the
sawing guide parallel to the cutting disc, the riving knife, the
push stick and the guard set in place, aligned and functioning
correctly.
• Do not release the work piece until it passes through the
cutting completely. Do not cut through the grain on warped
or twisted wood, or with no right edge that prevents it being
guided along the guide.
• Assure the wood to be cut has no nails or screws.
Additional Caution Measures
• This equipment shall only be used by people with
experience, instructed and trained in the use of wood
working with stationary machines.
• Wear anti-dust mask to reduce the risk of inhaling
dangerous dusts.
• Wear hearing protection.
• The equipment may throw debris toward the eyes
of the operator while in operation and cause severe
or permanent damage. Always wear safety goggles
complying with the ANSI-Z87.1 Standard.
• Be very careful when handling the cutting disc, in or out
the equipment. Prevent cuts, wear gloves.
• Do not try to remove wood chips while the disc is up and
running and the equipment is ON.
• Never stand on top of the equipment.
• DO NOT ASSEMBLE the equipment
WARNING
until double checking it is not connected and the power
switch is in the off position.
WARNING • DO NOT CONNECT the equipment to
the power supply, until it is completely assembled and the
operator has read and understood this instructions manual
entirely.
• To be able to carry out a good maintenance of the tool,
there shall be enough space around the machine.
CAUTION • Do not use metal cutting discs. This saw
is not built to cut metal materials or masonry. Failure to
comply with this note could cause severe injury.
Unpacking
• Remove the machine packing materials and fix it to its
base before operating.
• Keep a 12" free space around the
CAUTION
machine to gain working space. If working with large
materials, there shall be enough free space in front and rear
of the machine to be able to introduce and remove the
material with ease.
ENGLISH 5