Technical Specifications; Power Requirements - Truper SME-10 Instructivo

Technical specifications

Code
Description
Work Table
Disc
Voltage
Frequency
Current
Power
Speed
Work Cycle
Conductors
Insulation
WARNING
Avoid the risk of electric shock or severe injury. When the power cable gets damaged
it should only be replaced by the manufacturer or at a
The build quality of the electric insulation is altered if spills or liquid gets into the tool while in use.
Do not expose to rain, liquids and/or dampness.
WARNING Before gaining access to the terminals all power sources should be disconnected.

Power Requirements

WARNING Tools with main insulation are equipped with a polarized
plug. (one prong is wider than the other). This plug fits into any polarized
socket and can only be connected one way. If the plug cannot fit the socket,
turn it around. If it still cannot fit, contact a qualified electrician or install a
polarized socket. Do not alter the plug in any way. This type of insulation
eliminates the need of a three-parts connection cable with ground
connection or a ground connection electric system.
Ampere
Capacity
From 0 and up to 10 A
From 10 and up to 13 A
From 13 and up to 15 A
From 15 and up to 20 A
WARNING When using power tools outdoors use
Use". These extension cables are specially manufactured for outdoors use and reduce the risk of electric shock.
Tungsten Carbide 10" and 36 teeth
50 min work per 20 min rest. Daily Maximum 6 hours
16 AWG x 2C with 167°F Insulation Power
Power cord grips used in this product: Type "Y".
Build quality: Main Insulation
Thermal insulation on motor winding: Class B
Number of
Conductors
From 6 ft to 49 ft
3 (one grounded)
SME-10
16143
Table Saw
25-3/4" x 16"
127 V
50 Hz / 60 Hz
13 A
2,2 HP
4800 RPM
Class 0
Authorized Service Center.
Extension Gauge
| Higher than 49 ft
18 AWG
16 AWG
14 AWG
8 AWG
grounded extension cable labeled "Outdoors
16 AWG
14 AWG
12 AWG
6 AWG
3
ENGLISH