Parts; Mounting - Truper SME-10 Instructivo

Spacer
Cutting
Disc
Miter Guide
Slots
Cabinet
6
Miter
Guide
Scale and Pointer
of the Cutting Angle
Power

Mounting

Cable Orifices
Work Bench,
Pedestal or
Cabinet
Sieve
Mesh

Parts

Retractile Work
Guard Table
Height Control
and Disc Angle
Flywheel
Overload
Switch
Protector Switch
Mounting
• The saw shall be fixed to a stable, solid, fixed and leveled
work bench before starting it.
• Set the saw onto the work bench in the position most
adequate to work. Consider at least 12" free space from the
saw work bench to any wall or obstacle. If working with large
work pieces, you need even more free space to prevent the
work pieces to bump and make you lose control over the
tool.
• Use a pencil to mark the four mounting orifices on the
work bench surface.
• Remove the saw from the work bench and make four
5/16" diameter perforations in the penciled marks.
• In the center of the perforations, mark, cut and remove a
12" square to allow the exit of the sawdust into the saw
cabinet as well as allowing the proper ventilation to the
motor.
• To prevent touching the disc underneath the work bench,
cover the square orifice with sieve mesh. Do not use
mosquito net because it stops sawdust to exit.
• Fix the saw onto the bench with bolts 1/4" diameter, nuts
and flat washers (not included). Tighten gradually each bolt,
one by one to perfectly fix the cabinet base.
Sawing
Guide
Cut
Scale
Sawing Guide
Control
Cutting Angle
Blocking Knob