Adjustments - Truper SME-10 Instructivo

Flywheel Height Control
• The flywheel height control has a knob that facilitate
tuning it quickly.
• Mount the knob as shown and double check it turns freely
in its axis when turning the flywheel.
Table Insert
• To mount the table's insert (A), set the disc into the lowest
position and lift the retractile guard.
• Set the insert in place by tightening its two screws.
CAUTION • Do not use the saw without mounting
correctly the table insert.
Miter Guide
• Insert the miter guide rail (B) in one of the slots in the
work table. The guide scale shall face the operator.
Disc Height Adjustment
• To raise the cutting disc, turn the control flywheel (C)
counterclockwise.
• To lower the cutting disc, turn the flywheel clockwise.
CAUTION • Adjust always the disc height so it sticks
out approximately 1/8" over the upper part of the work piece.
If the disc sits higher, there is less space to manipulate the
work piece on the table and is less secure.
Cutting Angle Adjustment
• To make bevel cuts, modify the disc angle loosening the cutting angle
blocking knob (D).
• Push the control flywheel inwards (C) and turn it to the left or to the
right until getting the desired angle marked by the pointer (E).
• Tighten firmly the cutting angle blocking knob and pull the control
flywheel outwards.
CAUTION
• Always assure you tighten firmly the cutting angle
blocking knob before making bevel cuts.
Miter Guide
• The miter guide can be adjusted to ±60°, depending the
work to be carried out.
• Loosen the miter guide (F) to adjust the angle.
• Once the miter guide is in the desired angle shown with
the pointer (G), tighten the knob firmly.
8
ENGLISH
Mounting
B

Adjustments

E
E
A
D
C
C
F
G