Template To Make Tools To Push The Work Piece - Truper SME-10 Instructivo

Template to Make Tools
to Push the Work Piece
B
A
1/2"
C
Pusher
• To make the pusher (A) use 1/2", 3/4" wood or a
lower thickness of the material to be cut with a table
saw.
• To make the handle of the pushing block (C) use 1/2",
and for the block, use wood not smaller than 1/2".
CAUTION • Use hard wood or plywood to make
these tools.
• Each square in the templates equals 1/2".
Notch and handle
in angle to prevent
Handle
the hand sliding
towards the
cutting disc
Optional
Orifice
14
ENGLISH