Connection And Start-Up - Migatronic OMEGA2 Guía De Usuario

Connection and start-up

Warning
Read warning notice and
instruction manual carefully prior
to initial operation and save the
information for later use.
Unpacking the OMEGA C
2
After unpacking and prior to use, proceed as follows (see
drawing):
Permissible installation
Mains connection
Connect the machine to the correct mains supply. Please
read the type plate (U ) on the rear side of the machine.
1
yellow/green
brown
black
grey
yellow/green
brown
black
grey
0
l
1
Important!
In order to avoid destruction of plugs
and cables, good electric contact is
required when connecting earth cables
and welding hoses to the machine.
3x400V
3x230-400V (boost)
L1
L2
L3
N
1x230-400V (boost)
L
N
2
Connection of welding hose
Fastening the torch holder
Lifting instructions
Lifting hooks can be used at the OMEGA
sack barrow for lifting with a crane (figures 1 and 3).
The OMEGA trolley with four wheels cannot be lifted with
2
a crane but only manually using the handle (figure 2).
The machine must not be lifted with a mounted gas
cylinder!
Fig. 1 Fig. 2
Do not lift the machine by the
handle.
Do not step on the handle.
11
S and the OMEGA
2 2
Fig. 3