Connection And Operation; Fault Symbols - Migatronic FOCUS STICK 120 E PFC Guía De Usuario

Connection and operation

Warning
Read warning sheet and
this user guide carefully
before the equipment is
installed and in operation.
Permissible installation
Mains connection
Connect the machine to the correct mains supply.
Please read the type plate (U
the machine.
Important!
In order to avoid destruction of
plugs and cables, good electric
contact is required when
connecting earth cables and
welding hoses to the machine.
4
3
1. Mains connection
2. Power switch
3. Connection of earth clamp or electrode holder
4. Connection of earth clamp or electrode holder
Connection of electrode holder for MMA
The electrode holder and earth cable are connected
to plus connection (6) and minus connection
(4). Observe the instructions from the electrode
supplier when selecting polarity.
Switch on, press, weld
• Switch on the welding machine on the main
• Adjust the welding current
• The machine is now ready to weld

Fault symbols

) on the rear side of
1
Leave the machine on until the built-in fan has
cooled it down.
2
1
switch (2)
Temperature error
The indicator flashes, when the power source is
overheated.
5