Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
work with approved safety equipment, such as those dust masks that are specially
designed to filter out microscopic particles.
• Avoid prolonged contact with dust from power sanding, sawing, grinding,
drilling, and other construction activities. wear protective clothing and wash
exposed areas with soap and water. Allowing dust to get into your mouth, eyes, or
lay on the skin may promote absorption of harmful chemicals.
wARNiNg
: use of this tool can generate and/or disperse dust, which may
cause serious and permanent respiratory or other injury. Always use NIOSH/
OSHA approved respiratory protection appropriate for the dust exposure. Direct
particles away from face and body.
CAuTiON
: wear appropriate hearing protection during use. under some conditions
and duration of use, noise from this product may contribute to hearing loss.
The label on your tool may include the following symbols.
V ........................... volts
Hz ......................... hertz
min ........................ minutes
..................... direct current
.......................... Class II Construction
......................... safety alert symbol
.../min .................... revolutions or
mOTOR
Be sure your power supply agrees with nameplate marking. 120 Volts AC only means
your tool will operate on standard 60 Hz household power. Do not operate AC tools on
DC. A rating of 120 volts AC/DC means that you tool will operate on standard 60 Hz AC
or DC power. This information is printed on the nameplate. Lower voltage will cause
loss of power and can result in over-heating. All Black & Decker tools are factory-tested;
if this tool does not operate, check the power supply.
Extension Cords
When using an extension cord, be sure to use one heavy enough to carry the current
your product will draw. An undersized cord will cause a drop in line voltage resulting
in loss of power and overheating. The following table shows the correct size to use
depending on cord length and nameplate ampere rating. If in doubt, use the next heavier
gage. The smaller the gage number, the heavier the cord.
Safety warnings and instructions: Sanders
• ALwAyS uSE PROPER EyE AND RESPiRATORy PROTECTiON.
• Clean your tool out periodically.
• Before using the tool on metal workpieces or workpieces containing metal, make sure
to remove the dustbag.
• Wear gloves when working with metal workpieces.
Other important Safety warnings and instructions
Volts
120V
240V
Ampere Rating
More
Than
0
6
10
12
reciprocations
per minute
SAVE ThESE iNSTRuCTiONS
minimum gage for Cord Sets
Total Length of Cord in feet
0-25
(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
0-50
(0-15,2m) (15,2-30,4m) (30,4-60,9m) (60,9-91,4m)
Not more
Than
-
6
18
-
10
18
-
12
16
-
16
14
A ......................... amperes
W ........................ watts
n o ....................... no load speed
26-50
51-100
51-100
101-200
American Wire Gage
16
16
16
14
16
14
12
Not Recommended
4
.......................alternating current
........................ earthing terminal
101-150
201-300
14
12
12
Publicidad
Tabla de contenido
