Extension Cords - Black and Decker MOUSE Manual De Instrucciones

Extension Cords

When using an extension cord, be sure to use one heavy enough to carry the current your
product will draw. An undersized cord will cause a drop in line voltage resulting in loss of
power and overheating. The following table shows the correct size to use depending on cord
length and nameplate ampere rating. If in doubt, use the next heavier gauge. The smaller
the gauge number, the heavier the cord.
volts
120V
240V
Ampere Rating
More
Than
0
6
10
12
Symbols
The label on your tool may include the following symbols.
V ........................... volts
Hz ......................... hertz
min ........................ minutes
...................... direct current
.......................... Class II Construction
......................... safety alert symbol
wARNING: Some dust created by power sanding, sawing, grinding, drilling, and
other construction activities contains chemicals known to the State of California
to
cause cancer, birth defects or other reproductive harm. Some examples of these
chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry products, and
• arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you do this type of
work. To reduce your exposure to these chemicals: work in a well ventilated area, and
work with approved safety equipment, such as those dust masks that are specially
designed to filter out microscopic particles.
• Avoid prolonged contact with dust from power sanding, sawing, grinding, drilling,
and other construction activities. wear protective clothing and wash exposed areas
with soap and water. Allowing dust to get into your mouth, eyes, or lay on the skin may
promote absorption of harmful chemicals.
wARNING: Use of this tool can generate and/or disburse dust, which may cause
serious and permanent respiratory or other injury. Always use NIOSH/OSHA
approved respiratory protection appropriate for the dust exposure. Direct particles away
from face and body.
Safety warnings and Instructions: Sanders
• ALwAyS USE PROPER EyE AND RESPIRATORy PROTECTION.
• Clean your tool out periodically.
All manuals and user guides at all-guides.com
Minimum Gauge for Cord Sets
0-25 26-50
(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
0-50 51-100
(0-15,2m) (15,2-30,4m) (30,4-60,9m) (60,9-91,4m)
Not more American Wire Gage
Than
- 6 18
- 10 18
- 12 16
- 16 14
Total Length of Cord in feet
51-100 101-150
101-200 201-300
16 16 14
16 14 12
16 14 12
12 Not Recommended
A ......................... amperes
W ........................ watts
.......................alternating current
n o ....................... no load speed
........................ earthing terminal
.../min ..................revolutions or
reciprocations per minute
4