GreenWorks Tools 22157T Manual De Usuario página 17

ENGLISH
Chargers
Warning! Your charger has been designed for a
specific voltage. Always check that the mains voltage
corresponds to the voltage on the rating plate.
Warning! Never attempt to replace the charger unit
with a regular mains plug.
• Use your Greenworks tools charger only to charge the
battery in the appliance/tool with which it was supplied.
Other batteries could burst, causing personal injury and
damage.
• Never attempt to charge non-rechargeable batteries.
• If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Greenworks tools Service
Centre in order to avoid a hazard.
• Do not expose the charger to water.
• Do not open the charger.
• Do not probe the charger.
• The charger must be placed in a well ventilated area
when charging.
Symbols on the charger
The following symbols are found on your charger:
Your charger is double insulated; therefore no
earth wire is required. Always check that the
mains voltage corresponds to the voltage on the
rating plate. Never attempt to replace the charger
unit with a regular mains plug.
If the cord is damaged, it must be replaced by the
manufacturer or an authorised Greenworks tools
Service Centre in order to avoid a hazard.
The charger is intended for indoor use only.
Read the instruction manual before use.
8
(Original instructions)
Features
1. On/off switch
2. Lock-off button
3. Main handle
4. Trimmer head
5. Blade
6. Blade sheath
7. Battery
8. Charger
9. Charging indicator
Assembly
Warning! To prevent accidental operation, ensure that the
battery is removed and that the blade sheath is in place on the
blades before performing the following operations. Failure to
do this could result in serious personal injury.
Fitting and removing the trimmer head (fig. C)
Fitting the trimmer head
• Align the arrow on the end of main handle (3) with the
arrow on the trimmer head (4).
• Push the trimmer head (4) onto the handle (3) till the
red line.
• Fasten the trimmer head cam lock (11) .
Warning! Periodically check the connections to ensure that
they are tightened securely.
Removing the trimmer head
• Rest the handle (3) on the ground, loosen the trimmer
head cam lock (11) and push lock button (15), then take
off the trimmer head (4).
Adjusting the trimmer head angle (fig. D)
The trimmer head pivots 105° and can be locked into 7
positions within that range.
Warning! To avoid being pinched, wear gloves and hold the
unit as shown.
• Rest the handle (3) on the ground, push the pivoting button
(13) down and move the trimmer head (4) as required. Make
sure the trimmer head clicks into place.
Telescoping the handle (fig.F)
• Rest the handle (3) on the ground.
• Loosen the handle cam lock (12) and adjust the handle
shaft to a comfortable length.
• Fasten the handle cam lock.
Fitting and removing the battery (fig. B)
• To fit the battery (7), line it up with the receptacle on the
tool. Slide the battery into the receptacle and push until
the battery snaps into place.
• To remove the battery, push the release button (10) while
at the same time pulling the battery out of the receptacle.
10 . Release button
11 . Trimmer head cam lock
12 . Handle cam lock
13 . Pivoting button
14 . Second handle
15 . Lock button
16 . Front trigger