Installation Instructions; Location - Hayward SUMHEAT SHE1901 Guia Del Usuario

Installation instructions

Location

The location of your heat pump is very important in order to optimise the
performances of the device. You should also arrange easy access for
maintenance.
Your heat pump is designed for external installation and MUST NOT be
installed in a closed place such as a garage or "pool house", in order to avoid
any risk of recirculation of air which would affect the performances of the
heat pump.
The heat pump must be placed as close as possible to the pump and filter of
your pool in order to minimise load losses. Do not however forget to observe
a minimum clearance of at least 60 cm around your heat pump. Avoid the
use of right angle bends and small radius bends. It is however essential to
respect the safety distance required by the installation standard in force
(p30).
Mount the unit on a sturdy base,
preferably a concrete slab or a set
of blocks. The base should be com-
pletely isolated from the building
foundation wall to prevent possible
transmission of sound or vibration
into the building. The size of the base
should not be less than 1m x 1m.
All of the heat pump models use a
ultra-quiet ventilation system. The air
is pumped in through the evaporator
and pumped out through the top of
the device. A clearance distance of
at least 1.5 m must be respected at
the top of the device so that the air
circulates freely around the heat pump.
A complete clearance area of at least
60 cm must also be observed all around
the heat pump. This will maximise the
functionality of your device as well as
access for programming and maintenance.
26