Care And Cleaning; Cleaning The Operating Valve - Fagor Helix Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Care and Cleaning

1.
The Helix Pressure Cooker is made of high-quality, heavy gauge, stainless
steel.
2.
The pressure cooker pot is dishwasher safe but the lid is not. The lid
should be washed by hand with warm water, mild dishwashing soap and
a nonabrasive cleaning pad. Do not use metal scouring pads or abrasive
cleaners as they will scratch the pot and possibly ruin the finish.
3.
To remove stubborn stains and any discoloration in the interior of the
pressure cooker, try adding the juice of half a lemon and 1 to 2 cups of water
to the pressure cooker pot. Cook at high pressure for 15 minutes, and then
remove from heat. Let pressure release naturally, and then wash as usual.
4.
After cleaning, towel dry with a clean, soft kitchen cloth.
5.
In order to extend the life of the silicone gasket, remove after each use and
wash with warm water and mild, dish washing soap. Rinse and dry well, then
cover with a thin coat of vegetable oil before replacing. For increased safety
and best results, the silicone gasket should be replaced approximately every
12-18 months, depending on the usage. You can order a new gasket by
calling Fagor Customer Service Number to receive an order form at: 1-800-
207-0806, or by going to the online shop section of our website: www.
fagoramerica.com .
6.
To store, DO NOT LOCK THE LID IN PLACE. Simply place the lid upside
down on top of the pressure cooker pot. This will avoid the risk of a vacuum
forming inside the cooker during storage, which would make the opening of
the lid difficult. It will also prevent stale odors from forming inside the cooker.
7.
Before using the Fagor Helix Pressure Cooker, always check the handles, to
make sure that they are securely screwed in place. If not, tighten the handle
screws with a screwdriver.
8.
Replacement Parts: Only use authentic replacement parts manufactured and
distributed by Fagor America, Inc. The use of any unauthorized parts and
or attachments may cause unit failure and will void any warranty protection
provided by the manufacturer. You can order spare parts by calling Fagor
Customer Service Number at: 1-800-207-0806, or by going to the online
shop section of our website: www.fagoramerica.com.
18

Cleaning the Operating Valve

After every use, check to make sure that the operating valve is clear of any
built-up particles. To do so, move the operating valve to the steam position and
remove the valve (see detailed instructions below). Clean it by running water
through it. Next, lift the lid up to the light and look through the hole under the
operating valve. Make sure you can see through it and there are no food particles
blocking it. If necessary, clean it with a small brush or pipe cleaner.
1.
TO REMOVE THE OPERATING VALVE FOR CLEANING PURPOSES:
Move the operating valve to the pressure release position. Jiggle the
operating valve side to side as you pull it gently upwards to remove it from
its socket.
2.
TO REPLACE THE VALVE AFTER CLEANING: Hold the operating valve over
the vent pipe and push it down until it is seated properly into position.
19

Publicidad

Tabla de contenido
loading

Tabla de contenido