Fuel Filter; Spark Plug - Shindaiwa EB633RT Manual Del Operador

fuel fIlTer

Level 1.
Tools required: 200 - 250 mm (8 - 10 in.) length of wire with one end
bent into a hook, clean rag, funnel, and an approved fuel container
DANGER
Fuel is VERY flammable. Use extreme care when mixing, storing
or handling.
1. Use a clean rag to remove loose dirt from around fuel cap and
empty fuel tank.
2. Use the "fuel line hook" to pull the fuel line and filter from the tank.
3. Remove the filter from the line and install the new filter.

spark pluG

Level 1.
Tools required:
19mm Spark Plug deep socket, Feeler gauge
IMPORTANT
Use only BPMR-8Y spark plug otherwise severe engine damage
may occur.
1. Remove spark plug , and check for fouling, worn and rounded center
electrode.
2. Clean the plug or replace with a new one. DO NOT sand blast to clean.
Remaining sand will damage engine.
3. Adjust spark plug gap by bending outer electrode.
4. Tighten spark plug to 150-170 kg/cm (130-150 in. lb.).
16
0.65 mm
(0.026 in.)