Oase BioPress 4000 Instrucciones De Uso página 14

- EN -
Installation
Attention! Dangerous electrical voltage.
Possible consequences: Death or serious injuries.
Protective measures:
• Only operate the unit with the protection hood fitted.
• Ensure that the unit is installed water-tight with a safety distance from the water of a minimum of 2 m.
Install the unit so that it is not exposed to direct sun radiation (max. 40 ºC).
How to proceed:
B
• Place the pressure filter in a flood protected position at a distance from the pond edge of at least 2m on firm and
level ground.
– As an alternative, the filter can also be partly buried up to approx. 5 cm below the closing clamps.
• The height difference between the filter lid and the free outlet point may be max. 2 m.
• Ensure unrestricted access to the cover to be able to carry out work on the unit.
Start-up
Attention! Dangerous electrical voltage.
Possible consequences: Death or severe injury.
Protective measures:
• Electrical units and installations with a rated voltage of U > 12 V AC or U >30 V DC located in the water:
Isolate the units and installations (switch off and disconnect from the power supply) before reaching into
the water.
• Isolate the unit before starting any work.
• Secure the unit to prevent unintentional switching on.
Attention! Never operate the unit with a water pressure of more than 0.2 bar!
How to proceed:
C
Important:
• Switch the pump on first, then the UVC clarifying unit.
• Do not operate the unit without water flowing through.
• The unit switches on automatically when power connection is established.
Switching on: Connect power plug to the socket.
• The control lamp is lit.
• The flow indicator flap in the transparent stepped hose adapter in the outlet moves.
Note:
• After a new installation, the unit only reaches its full biological cleaning effect after a few weeks.
• The full effect on bacteria is only reached as from a water temperature of + 10 °C.
• In the event of overheating, the installed temperature monitor switches the UVC lamp off automatically, the lamp
automatically switches on again once cooled down.
Check all connections for leaks.
Switching off: Disconnect the power plug.
14