Clearing Blockages; Cleaning, Maintenance And Ordering Spare Parts - EINHELL GE-CL 36/230 Li E Manual De Instrucciones Original

6.5 Speed control (Fig. 22)
The equipment is fi tted with a variable speed
trigger. To use it, turn the speed controller (Item
10) to the desired position. Use the equipment
only with the speed which is actually required and
do not let it run at a speed which is faster than
necessary.
1 = Minimum speed
MAX = Maximum speed
6.6 Turbo mode (Fig. 23)
If you need higher blowing power or suction
power for a short time, you can press the turbo
button (Item 26). Pressing the turbo button
increases the speed for a short time and with it
the blowing or suction power.
Important: Never press the turbo button for
any longer than necessary, in order to keep
the noise level down and extend the battery
operating time.

6.7 Clearing blockages

Danger!
•
Switch off the equipment, wait for the moving
parts to come to a standstill and remove the
batteries.
•
Wear protective gloves
•
Use suitable tools (e.g. a wooden stick)
1. Examine the tube for blockages. Tap the
suction tube carefully or use a wooden stick
to clear any blockages.
2. Empty the catch bag and remove it. Remove
the suction tube.
3. Examine the openings in the motor housing
for possible blockages. Remove the blockage
with a stick if necessary. Make sure that the
shredder is clear.
6.8 Charging the Li battery pack
The corresponding instructions can be found
in the original operating instructions for your
charger.
6.9 Battery capacity indicator (Fig. 20 / item
24)
Press the battery capacity indicator switch (23).
The battery capacity indicator (24) shows the
charge status of the battery using 3 LEDs.
All 3 LEDs lit:
The battery is fully charged.
Anl_GE_CL_36_230_Li_E_SPK7_USA.indb 14
EN
2 or 1 LED(s) lit:
The battery has an adequate remaining charge.
1 LED fl ashing:
The battery is empty, recharge the battery.
All LEDs fl ashing:
The battery pack has been deep-discharged and
is defective. Do not re-use or charge a defective
battery pack.
7. Cleaning, maintenance and
ordering spare parts
HAZARD!
Always take the battery out of the equipment
before starting any cleaning work.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it down with compressed air at
low pressure.
•
We recommend cleaning the equipment
immediately each time after use.
•
Clean the equipment regularly with a damp
cloth and some soft soap. Do not use
cleaning agents or solvents; these may
be aggressive to the plastic parts in the
equipment. Ensure that no water can get into
the interior of the equipment. The ingress of
water into an electric power tool increases the
risk of an electric shock.
•
After shaking out the catch bag, turn it inside
out and thoroughly clean it in order to prevent
mould and unpleasant odours from forming.
•
You can use soap and water to clean out a
heavily soiled catch bag.
•
Rub a bar of dry soap across the zipper teeth
if the zipper becomes difficult to pull.
•
Clean the vacuum/blower tube with a brush
upon evidence of dirt and grime.
•
Dirt and grime can make the switch (blower/
vacuum) more difficult to operate as a result
of the material that swirls up off the ground.
When this occurs, simply flip the switch back
and forth a few times, which should bring it
back to the normal feel.
- 14 -
08.07.2020 11:25:23