Descargar Imprimir esta página

CAME BX-A Manual De Instrucciones página 10

Ocultar thumbs Ver también para BX-A:

Publicidad

ENGLISH
Description
The ZBX6 control board is used as a
remote control for BX-A/BX-B series
230V single-phase automated sliding
gates.
The board is introduced and fixed in
place in the gearmotor's circuit board
holder (see assembly description on
page 6), at 230V (a.c.) in terminals L1
and L2.
The inlet is protected with two 5A
fuses, while the low voltage (24V)
control devices are protected with a 1A
fuse.
The accessorie's total capacity (24V)
should not exceed 20W.
Fixed operating time of 80 seconds.
Safety
Photocells can be connected to abtain:
- Re-opening during closure (2-C1), if
the photocells identify an obstacle
while the gate is closing, they will
reverse the direction of movement until
the gate is completely open;
-2-
GENERAL CHARACTERISTICS
- Total stop (1-2), shutdown of gate
movement without automatic closing, a
pushbutton or radio remote control
must be actuated to resume
movement.
- Automatic closing. The automatic
closing timer is automatically activated
at the end of the opening cycle. The
preset, adjustable automatic closing
time is automatically interrupted by the
activation of any safety system, and is
deactivated after a STOP command or
in case of power failure;
- "Operator present" . Gate operates
only when the pushbutton is held down
(the radio remote control system is
deactivated);
- Automatic closure time;
IMPORTANT: Disconnect the unit from
the main power lines before carrying
out any operation inside the unit.
Other functions
Adjiustments

Publicidad

loading

Este manual también es adecuado para:

Bx-bZbx6