Rocal G Serie Manual De Caracteristicas, Instalacion Y Funcionamiento página 15

1.13.1. Upper deflector shields (C25-C26-C27). The 2 central shields have three positions to
adjust the draught. It comes from the factory to its most open position and you will have to adjust it
according to the hollow of the conduit.
1.13.2. Bottom deflector shields. Under the upper shields above described, you can find the
bottom shields.
CAUTION:
To prevent these deflector shields to fall during its transportation,
they are blocked by some cardboard pieces located:
–Between the bottom and upper deflector shields
–On the upper deflector shields (access through the outlet flue duct)
1.14. Acceso para limpieza y seguridad. Es aconsejable dejar en el nicho del hogar un acceso
para la limpieza del aparato, el conector de humos y el conducto de la chimenea.
. USER'S GUIDE
2
ALL LOCAL, NATIONAL AND EUROPEAN STANDARDS MUST BE COMPLIED WITH
WHENINSTALLING THE APPLIANCE.
Warning: Do not operate or handle any part when the fireplace is working unless using the
exothermic glove.
2.1. First burnings. For proper first burnings, and for a reasonable time, the data on the
maximum loads described in the table of Technical features must be respected.
WARNING:
You must respect the maximum load allowed by the manufacturer of the
logs as well as the height of the recharge.
2.2. Combustion control. In order to get the performance and power of the value table, you must
follow the position settings in the table of Technical features.
2.2.1. Primary register (C28). It is located on the left side hand of the device. This register is used
only for the ignition or to help a poor combustion (this register can be identified by a fire flame).
2.2.2. Secondary register (C29). It is located on the right side hand of the device. It is used to
control and maintain the intensity of the combustion.
An excessive combustion must be avoided as well as too much temperature in the combustion
chamber. A symptom of this overtemperature is the glass bleaching.
Scrolling up and down activates these registers.
WARNING:
The positions indicated are according to technical characteristics table, in
any case these positions must be adapt according to the flue depression and
fuel quality.
2.3. Safety distances. Appliances, furniture and other flammable or breakable items (textiles,
electronics, wood, wallpaper, glass, chalk paper, etc..) must not approach any point of the product
it is seen, and bear in mind that the outputs hot air cannot be objects or flammable items without
safety distances described in the G: Technical characteristics.
Pag. 15