Installation Procedures - Rocal G Serie Manual De Caracteristicas, Instalacion Y Funcionamiento

. INSTALLATION PROCEDURES

1
ALL LOCAL REGULATIONS, INCLUDING THE ONES ACCORDING TO THE NATIONAL
OREUROPEAN NORMS MUST BE ACCOMPLISHED WHEN PROCEEDING TO INSTALL
THEFIREPLACE.
1.1. Monoblock fireplace. Steel-made fireplace, equipped with ember grill, ashtray drawer,
deflector plates, detachable collar for smoke connection, with external chamber for convection and
flue air vents at the top.
1.2. Moving the device. In order you can move the device easier and safer to the place of its
installation or it can be transported by a crane, you will find two rings at the top (C1), your Rocal
distributor also has a wheel kit to move the device from one place to another (C2).
1.3. Dismantling of the fireplace. To ease its transport to the inside of the house you can, if
necessary, dismantle the device in two parts: guillotine-type door kit and combustion chamber. To
do this you must first remove the sides and then the primary and secondary registers (C3-C4-C5-
C6).
Then remove the protector you will find just when opening the door. To do this, first you have to
remove the screws of the inside (C7), remove the protector and then the screws below it (C8) and
two more that are on both sides of the module (C9). Once all screws are removed, both sides will
be freed and ready to be separated.
CAUTION:
When joining the two parts again, the bottom joint must be
PERFECTLY PLACED.
1.4. Unlock and check of the door. Remove the plates fastening the door lock (C10). Once
unlocked, check if the guillotine-type opening mechanism works properly. Sometimes, due to
transport, installation, incorrect levelling, or even expansion produced with its use, the
counterweight system of the door may be unbalanced. To rebalance it, open the swing door: look
at the frame of the module, just in the middle, on the inside and you will find two screws. Loosen
them; add any weight or take it away to balance the door as needed.
Once balanced, close the door again to verify if it works correctly.
CAUTION:
Before COVERING THE MODULE it is very important you to
CHECK THE LEVELLING AND THE COUNTERWEIGHT OF THE DOOR. Make sure it
works properly.
1.5. Floor. This fireplace must be assembled on floors, which provide an adequate bearing
capacity.
If the resistance is not enough, a panel of balance would be required to distribute the whole weight
of the fireplace.
1.6. Adjustable leg (C11-C12). The leg is height adjustable and extendible, and it also allows us
to level the device through its 4 platens at their feed.
1.7. Smokestack (C13). A smoke connector from the adapter is needed to the smoke outlet.
This outlet must be in good conditions and certified by a professional.
It can also be possible to lengthen the pipe to the outdoors providing, in any case, the exact
diameter for the fireplace.
The installation procedures must be done under the regulations.
Pag. 13