Fader Start - Denon DN-X1500 Instrucciones De Operación

ENGLISH
6

FADER START

If the separately sold DN-S5000, DN-S3000, DN-D9000, DN-D4000 and etc. players are connected to LINE2, 4,
6 or 8, they can be started using the source input fader (Ch. Fader) or Crossfader, as long as the 3.5 mm stereo
mini cords have been connected.
LINE 2 LINE 4 LINE 6 LINE 8
MAIN ALPHA
DN-S5000
CD1
10
FADER FADER FADER FADER
LINE 2 LINE 4 LINE 6 LINE 8
DN-X1500
FADER FADER FADER FADER
MAIN ALPHA MAIN ALPHA MAIN ALPHA
3.5 mm stereo mini cord
DN-S5000
CD2
Channel Fader Start
Turn the INPUT ASSIGN
switch #4 to select the
desired source from LINE2,
1
4, 6 or 8.
Turn on the CH FADER START
switch @6 .
2
Move the source input fader
(Ch. Fader) !9 of CH-1, CH-2,
CH-3 or CH-4 control all the
way to the bottom.
RCA cord
3
4
Set the standby mode on CD player.
When you want to start the
player, move up the source
input fader (Ch. Fader) !9 and
the CD player will begin
5
playing.
NOTE:
• Channel Fader Start and Crossfader Start for the
same source will not operate simultaneously.
You must select from either one. If both CH
FADER START and CROSSFADER START A, B
switches are ON, priority will be the cross fader.
Crossfader Start
Turn the INPUT ASSIGN
switch #4 to select the
desired source from LINE2,
1
4, 6 or 8.
Using the CROSSFADER
ASSIGN switch !0 , assign the
2
channel or Sampler source into A
or B of Crossfader.
Turn on the CROSSFADER START A, B
switches !7 .
3
Slide the Crossfader !8 all the way in direction
opposite the source you want to start. (In the
following example, startup is done with the CD
player connected set to Assign A.)
4
5
Set the standby mode on CD player.
Use the CROSSFADER CONTOUR control @0
6
to control the cross fader startup curve.
When the Crossfader !8 is slid in the opposite
direction, CD player play will begin.
7