User Settings - Dri-Eaz LGR 6000Li Manual Del Propietário

USER SETTINGS

Only menu items followed by a greater-than symbol (>) can be adjusted. If no keys are selected for 5 minutes on screens: INLET
OUTLET, GRAIN DPR (INLET-OUTLET for 230V models), the display will return to normal display mode. In all the other menu items,
the display with return to the normal display mode after 20 seconds. Items without the symbol (>) are for information only and cannot be
changed or reset. See "System Messages" below for additional system status messages.
Press DISPLAY
MENU to proceed to
the next menu item. ↓
□
1. JOB HRS RESET >
˃
PWR INTERRUPT X
2. INLET OUTLET
For information only.
100ʹ 80% 115ʹ 30%
3. GRAIN DPR
Unit displays GPP if set to Fahrenheit or g/kg if set to Celsius. To change this setting, see menu item 9.
XX GPP
4. FILTER CHECKED
˃
XXX HRS >
5. COIL CLEANED
˃
XXX HRS >
6. HUMIDISTAT
˃
MODE OFF >
7. HUMIDISTAT
˃
SETPOINT XX% >
8. LANGUAGE
˃
ENGLISH >
9. TEMP UNITS
˃
ʹF >
10. COIL TEMP
For information only.
XXʹ
11. COMP CURRENT
For information only.
XX.X A
12. FIRMWARE
For information only.
3.XX FXXX-XXX
13. LIFE HOURS
XXXX HRS
(Returns to
top menu item.)
The following section available only on wireless-equipped units.
14. SENSOR ID
XXXXXXXXX
(Returns to
top menu item.)
AT THE END OF THE JOB
To reduce the possibility of drips when moving the
unit, follow these additional steps to ensure that all
water is removed from the unit.
07-02300C F600
Press ˃ MENU SELECTION to change the setting.
1. JOB HR RESET 0
Press ˃ to reset to 0.
PWR INTERRUPT 0
4. FILTER CHECKED
Press ˃ to clear filter hours.
0 HRS
5. COIL CLEANED
Press ˃ to clear coil hours.
0 HRS
Press ˃ to turn ON or OFF. For maximum dehumidification, make sure
6. HUMIDISTAT
MODE ON > HUMIDISTAT is OFF.
Press ˃ to cycle through 40%–90% at 5% increments (default is 50%).
8. IDIOMA
˃
ESPANOL >
9. TEMP UNITS
Press ˃ to change to °F or °C.
ʹC >
→
8. SPRACHE 8. LANGUE
˃
DEUTSCH > FRANCAIS >
NOTICE: The unit will complete the defrost cycle even if
the unit is turned off but still plugged in. If the unit is
unplugged during the defrost cycle, excessive water may
accumulate in the unit and may drip out when you move
the unit.
4
Press ˃ to change
language options.
Dri-Eaz Products, Inc.