Security Warnings - Astralpool 10892 Manual De Instalación Y Mantenimiento

9. STRIPPING DOWN THE LIGHT (Fig. 17)
Remove the upper screw from the face plate, incline the light and remove It from te niche interior on bringing it upwards.
Bring the light up to pool side.
10. BULB CHANGING
PAR LAMP (Fig. 18)
It is necessary to disassemble (see section 9) the light in order to be able to change the bulb.
Remove the 2 central screws (1) and the 10 nuts (2) whitch fix the face plate to the lamp housing.
Remove the bulb (3) with its connections and disconnect its two wires (4).
Change the bulb and reconnect everything on carrying out the reverse of the above. Be careful to correctly fit the 0-ring
(5) in its housing and ensure that all the nuts (2) are properly tightened.
(It is advisable to replace the 0-ring each time that the light is dismantled).
(Ensure that the replacement bulb has the same characteristics as the supplied PAR 56 300W 12 V bulb).
Before carrying out anu maintenance work electrically isolate the light.

11. SECURITY WARNINGS

This light has been designed for use in non sait water poois.
When in use, the light should be totally submerged under water,
The light installation should always be carried out in accordance with, EN 60598-2-18, IEC 364-7-702 regulations and
any local regulations with regards to special use low voltage installations.
Those involved in the installation of the light should be properly qualified for this type o! work.