Balluff BTL6-A301 Serie Manual Del Usuario página 14

BTL6-A/G301-M_ _ _ _-A1-S115
Micropulse AT Transducer in round profile housing
Contents
1 Safety Advisory ..................... 2
1.1 Proper application .................. 2
1.2 Qualified personnel ................ 2
1.3 Use and inspection ................ 2
1.4 Scope ..................................... 2
2 Function and
Characteristics ..................... 3
2.1 Function ................................. 3
3 Installation ............................ 4
3.1 Transducer installation .......... 4
3.2 Magnet installation ................ 4
4 Wiring .................................... 5
5 Startup .................................. 6
5.1 Check connections ................ 6
5.2 Turning on the system ........... 6
5.3 Check output values ............. 6
5.4 Check functionality ................ 6
5.5 Fault conditions ..................... 6
5.6 Noise elimination ................... 6
6 Programming ....................... 7
6.1 Principle ................................. 7
6.2 Programming Output 1 .......... 8
6.3 Programming Output 2 .......... 9
6.4 Changing the operating
mode .................................... 10
6.5 Factory setting ..................... 10
7 Versions (indicated on
part label) ............................ 11
7.1 Included in shipment ........... 11
7.2 Available stroke lengths ...... 11
8 Accessories ........................ 11
8.1 Magnet ................................. 11
8.2 Mounting brackets ............... 11
8.3 Connection cables,
connectors ........................... 11
9 Technical Data .................... 12
9.1 Dimensions, weights,
ambient conditions ............... 12
9.2 Supply voltage (external) ...... 12
9.3 Output signal,
potential-free ........................ 12
9.4 Overvoltage protection ......... 12
2
english
1 Safety Advisory
Read this manual before installing
and operating the Micropulse
Transducer.
1.1 Proper application
The BTL6 Micropulse transducer is
intended to be installed in a machine
or system. Together with a controller
(PLC) it comprises a position measur-
ing system and may only be used for
this purpose.
Unauthorized modifications and non-
permitted usage will result in the loss
of warranty and liability claims.
1.2 Qualified personnel
This guide is intended for specialized
personnel who will perform the
installation and setup of the system.
1.3 Use and inspection
The relevant safety regulations must
be followed when using the trans-
ducer system. In particular, steps
must be taken to ensure that should
the transducer system become de-
fective no hazards to persons or
property can result.
1.4 Scope
This guide applies to the model
BTL6-A/G301...A1-S115 Micropulse
transducer.
An overview of the various models
can be found in ➥ ➥ ➥ ➥ ➥ Section 7 Ver-
sions (indicated on part label) on
page 11.
Note: For special versions, which
are indicated by an -SA_ _ _ des-
ignation in the part number, other
technical data may apply (affect-
ing calibration, wiring, dimensions
etc.).