Changing The Operating Mode; Factory Setting - Balluff BTL6-A301 Serie Manual Del Usuario

BTL6-A/G301-M_ _ _ _-A1-S115
Micropulse AT Transducer in round profile housing
6 Programming (cont.)
6.4

Changing the operating mode

Starting from the factory setting ➥ ➥ ➥ ➥ ➥ Section 6.5 you can select the other operating modes, beginning with Mode 2 and
then Mode 3. (back to Operating Mode 1 ➥ ➥ ➥ ➥ ➥ Section 6.5 Factory Setting)
Operating mode 1 ➔ Single position measurement:
Factory setting Fig. 2-2
Operating mode 2 ➔ Differential measurement:
Operating mode 3 ➔ Single position measurement:
Fig. 2-3 until Serial-No. 0531xxxxx
Use this programming sequence to change the operating mode.
1) Turn off power to the BTL6
2) Programming input Lb = "on"
3) Turn on power supply
4) Wait until LED comes (4 s < t < 8 s)
and then Lb = "off"
5) Wait until LED is constant on (4 s < t < 8 s)
and then Lb = "on"
6) Wait until LED is constant on (4 s < t < 8 s)
and then Lb = "off"
7) Turn power off and on. ➔ new operating mode is active
8) Check programming of the outputs and reprogram if necessary
➥ ➥ ➥ ➥ ➥ Section 6.3
The Micropulse transducer is now ready to use.
6.5

Factory setting

The BTL is reset to factory defaults,
see Fig. 2-2
➥ ➥ ➥ ➥ ➥ page 3
1) Turn off power to BTL6
2) Programming input La = "on"
3) Turn on power
4) Wait until LED comes on (4 s < t < 8 s)
and then La = "off"
5) Wait until LED is constant on (4 s < t < 8 s)
and then La = "on"
6) Wait until LED is constant on (4 s < t < 8 s)
and then La = "off"
7) Turn power off and on. BTL is now ready to use.
10
english
Output 1 = Position value for Magnet 1
Output 2 = Position value for Magnet 2
Output 1 = Position value for Magnet 1
Output 2 = Differential value between Magnet 1 and Magnet 2
Output 1 = Position value for Magnet 1
Output 2 = Position value for Magnet 2
Lb = on ➔ Programming input Lb to 0 V
Lb = off ➔ Programming input Lb open
La = on ➔ Programming input La to 0 V
La = off ➔ Programming input La open
Flash time Code
On : Off
LED off
LED on
0.05 s : 0.05 s LED flashing rapidly
LED on
0.5 s : 0.5 s LED flashing very slowly
LED on
LED off
(output)
Flash time Code
On : Off
LED off
LED on
0.05 s : 0.05 s LED flashing rapidly
LED on
0.5 s : 0.5 s LED flashing very slowly
LED on
LED off
(output)