Technical Data; Orbital-Action Jig Saw - Hilti SJD 6 Manual De Instrucciones Original

You can find other system products approved for your product at your local Hilti Center or online at:
www.hilti.com
4

Technical data

4.1

Orbital-action jig saw

When powered by a generator or transformer, the generator or transformer's power output must be at
least twice the rated input power shown on the rating plate of the power tool. The operating voltage of
the transformer or generator must always be within +5% and -15% of the rated voltage of the power
tool.
The information given applies to a rated voltage of 230 V. The data may vary in the event of deviations
from the rated voltage and for country-specific versions. Please refer to the power tool's type
identification plate for details of its voltage, frequency, current and input power ratings.
Rated power input
Weight in accordance with EPTA procedure 01
Stroke rate under no load
Stroke length
Maximum cutting performance in wood
Maximum cutting performance in aluminum
Maximum cutting performance in unalloyed steel
Cutting angle (left/right)
Suction adapter outside diameter
4.2 Noise information and vibration values in accordance with EN 62841
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a
preliminary assessment of exposure.
The data given represent the main applications of the power tool. However, if the power tool is used for
different applications, with different accessory tools, or is poorly maintained, the data can vary. This can
significantly increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times when the tool is switched off, or
when it is running but not actually being used for a job. This can significantly reduce exposure over the total
working period.
Identify additional safety measures to protect the operator from the effects of noise and/or vibration, for
example: maintaining the power tool and accessory tools, keeping the hands warm, organization of work
patterns.
Noise emission values
Sound power level (L
WA
Uncertainty for the sound power level (K
Sound pressure level (L
Uncertainty for the sound pressure level (K
Total vibration
Vibration emission value for sawing wood sheets (a
Vibration emission value for sawing sheet metal (a
Uncertainty (K)
6 English
)
)
WA
)
pA
)
pA
)
h,B
)
h,M
2150158
*2150158*
SJD 6
850 W
2.4 kg
80 /min ... 3,000 /min
28 mm
150 mm
25 mm
10 mm
0°, 15°, 30°, 45°
27.5 mm
SJD 6
100.5 dB(A)
5 dB(A)
89.5 dB(A)
5 dB(A)
SJD 6
9.7 m/s²
8.0 m/s²
1.5 m/s²