Blowing Feature - RIDGID WD1456BR0 Manual Do Usuário

SP6824 WD1455BR0 PSE
Operation (continued)

Blowing Feature

Your Vac features a blowing port. It can
blow sawdust and other debris. Follow the
steps below to use your Vac as a blower.
!
WARNING: Always wear safety
eyewear before using as a blower.
!
WARNING: To reduce the risk of
injury to bystanders, keep them
clear of blowing debris.
!
CAUTION: Wear a dust mask if
blowing creates dust which might
be inhaled.
!
CAUTION: To reduce the risk of
hearing damage, wear ear protectors
when using the Vac/Blower for
extended time or in a noisy area.
4/19/12 2:22 PM
48
Page 48
1. Locate blowing port of your Vac.
2. Insert the locking end of the Dual-
Flex™ Locking Hose into the blowing
port of the Vac. The hose should snap
into place.
3. (Optional) Attach extension wand to
opposite end of hose, then place the
car nozzle on the wand.
4. Turn Vac on and you are ready to use
your Vac as a blower.
Swivel
End of
Hose
Extension Wand
(Optional)
Dual-Flex
Locking Hose
Utility Nozzle
(Optional)