3-2. Preparing and installing the tubing
Material: Phosphorous deoxidized copper seamless tubing (C1220T)
Tubing size: Choose tubing sizes according to tables 1-3, 1-4, 1-6.
Use tube with thickness as per Table 3.
Table 3
Tubing size (mm)
Exterior diameter
Wall thickness
Ø6.35
T0.8
Ø9.52
T0.8
Ø12.7
T0.8
Ø15.88
T1.0
Ø19.05
T1.0
Ø22.22
T1.0
Ø25.4
T1.0
Ø28.58
T1.0
Ø31.75
T1.1
Ø38.1
T1.35
Ø44.45
over T1.55
After cutting the tube, be sure to remove all burrs and finish tubing ends to the
correct surface. (The same must be done for branch tubes (purchased separately).)
When bending tubes, be sure the bend radius is at least 4 times the outer diameter
of the tube.
When cutting or bending tubes, be careful not to cause any pinching or blockage of
the tube.
• Prevent foreign substances such as dirt or water from entering the tube by
CAUTION
sealing the end of the tubes with either a cap or with tape.
Otherwise, this can damage the devices and result in malfunction.
Type
O
1/2 H or H
EN - 17
Fig. 16