Quick Installation Instructions - Polaris 3900 Sport Manual De Instalación Y De Uso

Quick Installation Instructions

1
Install the Universal Wall Fitting
Installs in minutes on pools with a dedicated cleaner return line.
1. Turn on the filtration pump and flush out the plumbing line.Turn pump off.
2. Remove the Universal Wall Fitting (UWF) from the Quick Disconnect and screw it
3. Turn the Quick Disconnect clockwise into the UWF and pull away to secure.
EN
2
Adjust Feed Hose To Fit Pool Length
1. Measure the deepest part of the pool. Cut leader hose, from end that attaches to
2. Attach leader hose to feed hose and connect hose to the pool wall at the return line.
into the return opening with the blue restrictor disk in place.
Dedicated
Return Line
Restrictor Disk
UWF
Quick Disconnect
Pressure Relief Valve
feed hose, so length is equal to the greatest depth of the pool.
Extend hose to farthest point of pool. The hose end must be within 15 cm longer or
shorter – of the farthest point. See diagram below.
If hose is too long: Separate hose at center swivel. Cut equal amounts of the
overage from feed hose section.
If hose is too short: Add a feed hose section, a swivel
and two hose nuts. Adjust to proper length.
Each feed hose section should be equal in length after adjustments.
3. After adjusting the length, position the hose floats as shown.
In-Line
UFW Filter
Feed Hose Floats
45 to 90 cm apart
Return
Line
Center
Swivel
4
Furthest
Point
Leader Hose
Length = Max. Depth
Leader Hose Floats
60 to 90 cm apart