Brady BBP 85 Guia De Inicio Rapido página 16

2. Place ribbon roll inserts over yellow drive cones on left, then
right sides.
3. Snap yellow flag into yellow memory cell.
4
4. Place left side of media roll insert over yellow drive cone, pull
toward left, then insert end of roll over opposite drive cone
5. Snap yellow flag into yellow memory cell.
2
3
5
6. Place leading edge of media between yellow media guide
and black media roller.
7. Slide yellow media guides so they fit against media.
8
8. Swing media wiper up until it rests on media (do not swing up
for die-cut media) .
9. Close printer cover by pressing down until it clicks into place.
16
6
7