How To Use The Lift In A Stroller - Emmaljunga Quadrolift Manual De Instrucciones

How to use the lift in a stroller

1
2
2a
3
48
• Engage the brake.
• Place the backrest and the footrest in horizontal position.
• Remove the bumper bar by unscrewing it with a star-headed screw
driver. Remove the bumper bar and the attachment pieces. Save
these in a safe place so that you can re-assemble it again when the
seat unit is to be used.
• Place the lift in the stroller.
WARNING!
• The seat unit fabrics must be assembled when the lift is placed in
the stroller.
• Always reassemble the bumper bar to the seat unit when the
Quadrolift is not in use.
With a lift he pram can be used from birth, then only use the seat unit
in the most reclined position. Make sure that the lift is positioned on
top of the restraint system to avoid the restraint system from coming
into the lift.
Securing the lift in the stroller (Only strollers with a 5-point har-
ness with two plastic prongs on each waist strap)
First locate the plastic clips below the apron (see the white arrow on
picture 1)
• Release the waist straps from the 5-point harness
• Click the waist straps into the plastic clips on the lift (see picture).
One on each side.
WARNING!
• This is a very important step to secure the lift onto the stroller.
Securing the lift in the stroller (Only strollers with a 5-point har-
ness with three plastic prongs on each waist strap)
• Pull the safety catches (2 pcs) which are placed under the lift, th-
rough the hole on each side of the fabric on the stroller seat fabric.
• Attach the safety catches to the D-rings, which are placed on either
side of the seat fabrics.
WARNING!
• This is a very important step to secure the lift onto the stroller.
• This is the way the lift should look when it is assembled correctly in
the stroller.
WARNING!
• Do not let the carrying straps hang outside the stroller. Place these
between the lift the seat unit, as shown on the picture.
Manual Quadrolift t v. 3.2