Handling And Operation - UFESA CP6500 Manual De Instrucciones

Handling and operation

PLACING, REMOVING & REPLACING ATTACHMENTS
●
Select appropriate attachment for your desired hair length.
1
Slide the comb attachment in the hair clipper housing guides.
2
Press the comb attachment release tab and slide the attachment to the desired
position.
Before hair trimming, always make sure the attachment comb is
firmly locked.
3
To replace / remove the comb attachment press the release tab and slide the
attachment out of the guides.
USE OF THE APPLIANCE
To cut the hair even, the attachment / blade must move freely
through the hair. Do not force the hair clipper quickly.
Cut the hair to the desired length stepwise, staring with the
longest attachment comb.
1
Place your selected attachment on the appliance (see section PLACING,
REMOVING & REPLACING ATTACHMENTS).
2
Set the position of the attachment comb to the desired length of haircut.
Before hair trimming, always make sure the attachment comb
is firmly locked.
3
Slide the ON/OFF switch up to turn the hair clipper on.
D
E