Electrical Connection; Downloading Further Instructions - Balluff BTL5-S1 Serie Instrucciones Breves

BTL5-S1 _ _ (B)-M _ _ _ _ -K(8)-SR115
Magnetostrictive Linear Position Sensor – Rod Style
The CE Mark verifies that our products
meet the requirements of the current
EMC Directive.
Intended use
The BTL magnetostrictive linear position sensor, together
with a machine controller (e.g. PLC), comprises a position
measuring system. It is intended to be installed into a
machine or system and used in the industrial sector.
Flawless function in accordance with the specifications in
the technical data is ensured only when using original
Balluff accessories. Use of any other components will void
the warranty.
Opening the BTL or non-approved use are not permitted
and will result in the loss of warranty and liability claims
against the manufacturer.
General safety notes
Installation and startup may only be performed by
trained specialists.
The operator is responsible for ensuring that local safety
regulations are observed. In particular, the operator must
take steps to ensure that a defect in the BTL will not result
in hazards to persons or equipment.
If defects and unresolvable faults occur in the BTL, take it
out of service and secure against unauthorized use.

Downloading further instructions

A complete user's guide can be downloaded from the
Internet at www.balluff.com or requested via e-mail from
service@balluff.de.
34 40-1
2)
6
Mounting
25
surface
20
1 english
Damping zone 2)
Nominal length =
Measuring range
Positionsgeber 3)
Version D1
...-K-... 10,2 mm
...-K8-... 8 mm
Dimensions and function
The BTL contains the waveguide which is protected by an
outer stainless steel tube (rod). A magnet is moved along
the waveguide. This magnet is connected to the system
part whose position is to be determined.
The magnet defines the position to be measured on the
waveguide.

Electrical connection

Pin assignment of SR115 (view from
above on BTL), 8-pin M12 circular plug
Pin
1
2
3
4
5
6
7
8
1) Unassigned leads that are not used can be connected to the GND on
the controller side but not to the shield.
60
G
G
Thread
M4x4/6 deep
No thread
2) Unusable area
3) Not included in scope of delivery
UL approval
File No.
E227256
Signal
+Clk
+Data
–Clk
Not used 1)
–Data
GND
20...28 V
Not used 1)
Ø 79
Ø 64
6 holes to fasten
the BTL