Electrical Connection; Connector S32/Cable Connection - Balluff BTL7-A Serie Manual De Instrucciones

BTL7-A/C/E/G _ _ _ -M _ _ _ _ -A(8)-SA211/SA311-S32/S115/S135/KA_ _/FA_ _
Magnetostrictive Linear Position Sensor – Rod Style
4
Installation and connection (continued)
Supporting rod made of non-magnetizable material
Figure 4-7: Example 2, BTL installed with supporting rod
4.4.1

Connector S32/cable connection

S32 Wire color -A_10
pin
1 YE yellow Not used
2 GY gray
3 PK pink 10...0 V
4 RD red
5 GN green 0...10 V
8 WH white
6 BU blue
7 BN brown
Unassigned leads can be connected to the GND on the controller side but not to the shield.
1)
Reference potential for supply voltage and EMC-GND.
2)
Tab. 4-2: Connection assignment BTL7...-S32
4.4.2 Connector S115
S115 -A_10 -G_10
pin
1
2
3 10...0 V 10...–10 V
4
5 0...10 V –10...10 V
8
BTL7-_1_ _-...
6 GND
7 20 to 28 V
1) Unassigned leads can be connected to the GND on the controller side but not to the shield.
2) Reference potential for supply voltage and EMC-GND.
Tab. 4-3: Connection assignment BTL7...-S115
www.balluff.com
Magnet
(e.g. BTL-P-1028-15R)
-G_10 -C_00 -C_70
0 to 20 mA 20 to 0 mA 4 to 20 mA
1)
0 V
10...–10 V
La (programming input)
–10...10 V
Lb (programming input)
BTL7-_1_ _-...
GND
2)
20 to 28 V
-C_00 -C_70
0 V (pin 3)
0 V (pin 5)
La (programming input)
0...20 mA 20...0 mA
Lb (programming input)
2)
4.4

Electrical connection

Depending on the model, the electrical connection is made
using a cable or a connector.
The connection or pin assignments for the respective
version can be found in Tab. 4-2 to Tab. 4-4.
Note the information on shielding and cable
routing on page 12.
-E_00 -E_70
20 to 4 mA
Not used 1)
Not used
1)
BTL7-_5_ _-...
GND
2)
10 to 30 V
-E_00 -E_70
Not used
1)
4...20 mA 20...4 mA
BTL7-_5_ _-...
GND
2)
10 to 30 V
Figure 4-8: Pin assignment of
S32 (view from above
on BTL), 8-pin M16
circular plug
Figure 4-9: Pin assignment of
S115 (view from
above on BTL), 8-pin
M12 circular plug
english 11