Windsor Saber Blade 12 Manual Del Usaurio página 11

Error
Appliance cannot
be started
Insufficient water
quantity
Fresh water reser-
voir drips when re-
filled
Insufficient vacu-
um performance
Insufficient clean-
ing result
Brush does not
turn
Remedy
Check if the mains plug is connected.
Check clean water level, refill tank if necessary.
Clean the water distributor (see chapter "Cleaning the water
distributor").
Pull off the valve on thesolution tank (Fig. 4, see inside front
cover) and rinse in lukewarm water.
Pull off the valve on the solution tank (Fig. 4, see inside front
cover) and rinse in lukewarm water.
Empty the solution tank.
Lock the recovery tank in place on the appliance.
Clean the seals between recovery tank and cover and
check for tightness, replace if required.
Check that all squeegee are locked into place in the clean-
ing head.
Squeegee worn, replace if required.
Check that both suction tube parts are correctly attached to
the suction tube connection.
Check the suction tube and the suction channel in the
cleaning head for obstruction and remove if necessary (see
"Cleaning suction tube").
Check the brush for wear, replace if required.
Check if foreign matters are blocking the brush; remove for-
eign matter if required.
11
English