Standard Filter Cleaning / Installation Instructions; Premium Carbon Filter Installation Instructions - Friedrich SQ06 Manual De Instalación Y Funcionamiento

Standard Filter Cleaning / Installation Instructions

STEP 1. Open front cover and remove permanent/washable mesh
filter by grasping the filter grip and pushing the filter holder
up and outward.
Figure 2

Premium Carbon Filter Installation Instructions

Please follow the instructions below to install the Friedrich carbon filter. The carbon
filter should be replaced after 300 hours of operation, 3 months, or more often if
needed for maximum effectiveness.
When you replace the carbon filter, clean the washable mesh filter if dirty. Allow
mesh filter to dry before reinserting.
STEP 1. Remove the black plastic filter frame from the unit following the
instructions above or on the inside of the front cover.
STEP 2. Lay the black plastic filter frame on a flat surface, with the 6
filter frame hooks facing upward.
Figure 4
6
FILTER
DOOR
FRR075
FILTER FRAME
HOOKS (6)
FRR077
STEP 2. Clean the front mesh frame by washing the dirt from the filter.
Use a mild soap solution if necessary. Allow filter to dry.
STEP 3. Install filter back into the unit. See also "Filter Removal
Procedure" on the inside of the front door.
Figure 3
FILTER FRAME
INSTRUCTIONS
Place the carbon filter over the filter frame so that the carbon
filter's 6 installation holes align with the 6 filter frame hooks.
(Figure 4)
Secure the carbon filter to the filter frame. Make sure that
all 6 filter frame hooks are inserted through all 6 installation
holes of the carbon filter. The installation hooks will hold the
filter securely.
STEP 3. Place the black plastic filter frame with the carbon filter
installed (Figure 5) back into the front of the unit, following
the instructions on the inside of the filter door.
Carbon filter is now ready for use!
Figure 5
FILTER
DOOR
FRR076
FRR078