Allmatic XTILUS Serie Manual Del Usuario página 22

7.3 ADJUSTMENT OF MECHANICAL LIMIT SWITCHES
XTILUS is supplied with a mechanical limit switch for the opening (Fig. 10, 11), but it is also possible to install the mechanical
limit switch for the closing (optional), to stop opening or closing in case the gate is without ground stops.
To adjust, loosen the screw located on the limit switch and move it to the desired position. Tighten the screw on the limit switch
(Fig. 12).
WARNING!
FOR OPTIMUM XTILUS OPERATION IT IS RECOMMENDED TO USE ALL THE LENGTH OF THE STEM STROKE FOR EVERY
MOVEMENT. IF YOU DO NOT USE ALL THE AVAILABLE STEM STROKE, USE THE STEM STROKE AS MOST POSSIBLE
TOWARDS THE POINT OF THE MOTOR, AND NOT TOWARDS THE REAR.
22 / 52
ATTENZIONE!
utilizzare una livella per il
posizionamento delle piastre
Fig. 11
6-1624846
Fig. 9
Fig. 10
rev. 16 13/11//2018