Power Sources - Roadstar HRA-590D+ Manual De Instrucciones

POWER SOURCES

AC POWER: You can power your portable stereo system by plugging the AC/DC
adaptor into the DC plug at the back of the unit and into a wall AC power outlet.
Check that the rated voltage of your appliance matches your local voltage.
BATTERY POWER: To use the radio with batteries, disconnect the AC/DC adaptor
and insert 4 × "AA" batteries into the compartment (10).
Be sure that the batteries are inserted correctly to avoid damage to the appliance.
Remove the batteries when the radio will not be used for a long period of time, as this
will cause leakage to the batteries and subsequently damage to your radio.
TO USE THE RADIO
1. Press the [Power] button (1) to power on;
2. Press [MODE] (2) to select DAB, FM or Aux input;
3. Adjust the volume with the [VOLUME+/-] buttons (7) to the desired level;
4. To power off the radio, press the [POWER] button (1).
Note: For a better reception reorient the antenna.
TUNE DAB STATION
1. DAB: Adjust radio frequency to your desired station by pressing
buttons (5) and then press [SELECT] (6);
Note: In case there is No DAB Service, press & hold the [MENU] button (3) and se-
lect "Full Scan" to start scanning with [CHANNEL -/+]
[SELECT] (6) button.
FM STATION SCAN
1. FM: Adjust radio frequency to your desired station by pressing
buttons (5). For Auto Scan, press and hold for 2 seconds
(5);
PRESET DAB OR FM
1. Set the desired radio station frequency as explained previously;
2. Press and hold for 2 seconds the [PRESET] button (4), select with [CHANNEL -/
+] buttons (5) desired PRESET position and press
save;
RECALL A PRESET STATION
1. Press the [Preset] button (4);
2. Select the desired preset by pressing
3. Confirm with the [SELECT] button (6).
INFO
When the radio station is playing, press the [INFO] button (3) repeatedly to cycle
through the information broadcasted by the radio as follow:
UNDER DAB
•
DLS (Dynamic Label Segmenting): Radio text broadcasted from the DAB station
English
buttons (5), confirm con
the [PRESET] button (4) to
[CHANNEL -/+] button (5);
[CHANNEL -/+]
[CHANNEL -/+]
[CHANNEL -/+] buttons
2