Manual Scan - Roadstar TRA-300D+ Manual De Instrucciones

sert 4 × "LR6" batteries into the compartment (16).
Be sure that the batteries are inserted correctly to avoid damage to the appliance.
Remove the batteries when the radio will not be used for a long period of time, as this will
cause leakage to the batteries and subsequently damage to your radio.
POWER ON/OFF
1. Switch the [POWER] button (13) to ON to power on the radio.
2. Switch the [POWER] button (13) to OFF to power off the radio.
TO USE THE RADIO
1. Press and hold the [POWER] button (12) to power on;
2. (The first time you power on the radio, the radio will scan the DAB radio stations auto-
matically. It will display and play the first station after the scan is done);
3. Select the band (DAB or FM) by pressing the [DAB/FM] button (2);
4. Adjust radio frequency to your desired station;
5. Adjust the volume with the [VOLUME +/-] (11) to the desired level;
6. To power off the radio, press the [POWER] button (12) for 2 seconds.
Note: For a better reception reorient the antenna.
DAB+ PRESET
To store a preset, select preferred station press [PRESET] button (9) for 2 seconds. The
LCD will show "Preset Store", use [◄►] (8) buttons to choose preset number from 1 to 10
you wish to use. Press [ENTER] (7) to store.
RECALL A PRESET STATION
1. Press the [PRESET] button (9);
2. Select the desired preset by using the [◄►] (8) buttons
3. Confirm with the [ENTER] button (7).
You can select with [PRESET LOCATION BUTTONS] (10) from 1 to 5 preset stations. To
select Preset from 6 to 10, press and hold the relevant button.
FM STATION SCAN
Press and hold the [INFO/MENU] (4) button for 2 seconds. Press [ENTER] button (7) to
confirm.
You can choose with [◄►] (8) buttons STRONG STATIONS ONLY, or ALL STATIONS.
Confirm with [ENTER] button (7) .
Press [SCAN] (6) button to SCAN radio.

MANUAL SCAN

Press [◄►] (8) buttons to scan a station. When station found, the scan will stop.
To fine tune the frequency you can press [◄►] (8) buttons to advance in 0.05 MHz incre-
ments.
DAB SCAN
There are 2 types of scan. Quick scan and Auto scan.
Quick scan: press [SCAN] (6) button
English 2