Other Information For This Machine; Laser Safety - Ricoh SP C840 DN Manual De Instrucciones

5. Other Information for This Machine

Laser Safety

CDRH Regulations
This equipment complies with requirements of 21 CFR Subchapter J for class
I laser product. This equipment contains four 4ch-Laser Diode Arrays (4ch-
LDA). Laser diodes are AlGaInP, 657–663 nanometer wavelength for each
emitter. The beam divergence angle is 16 degrees (minimum) and 25 degrees
(maximum) in the vertical direction, and 7 degrees (minimum) and 13 degrees
(maximum) in the horizontal direction, and laser beams are generated in
Continuous Wave (CW) mode. Each 4ch-LDA has four light sources and the
maximum output power of the light source is 17 milliwatt.
Caution:
Use of controls or adjustments or performance of procedures other than those
specified in this manual might result in hazardous radiation exposure.
Notes to Users in the United States of America
FCC Requirements
Note:
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio /TV technician for help.
Caution:
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This transmitter must not be co-located or operated in conjunction with any
other antenna or transmitter.
15