jbc RA 5150 Manual Del Usuario página 3

We appreciate the trust you have shown in JBC by purchasing this station.
It has been manufactured with the highest standards of quality to ensure reliable
service. Before starting up the apparatus, we recommend you read these instructions
carefully.
FEATURES
Station composition
RA 5150 EU:
RA 5150 UK:
RA 5150 USA:
- Control Unit 230V
- Control Unit 120V
- Desoldering iron 75W
- Soldering iron 50W
- Soldering iron stand US 1000
- Desold. iron stand UD 1500
- External desoldering air filter
- Set of tools and
replacement filters
- Tip removal device
- Instructions manual
Weight of packaged equipment: 3,8 kg
Besides the soldering and desoldering irons
supplied with this station, the Control Unit will
also take the 20W Ref. 3000000, 60W
Ref. 3020000 with solder feed and 70 W
Ref. 3070000 soldering irons.
Soldering
temperature selection
Soldering connector
Equipotential terminal
Desoldering connector
Ref. 5150200
Ref. 5150201
Ref. 5150100
Ref. 5330200
Ref. 5330100
Ref. 3040000
Ref. 3010000
Ref. 0290100
Ref. 0290150
Ref. 0781184
Ref. 0781181
Ref. 0114108
Ref. 0965405
External desoldering air filter
The desoldering iron is connected to the station following the below procedure:
The cable connection of the desoldering iron is connected to the desoldering connector of
the station and the vacuum hose is connected to the external desoldering air filter, which is
connected to the vacuum connection of the station. Very important, it is essential to connect
the mentioned filter to prevent from damaging the vacuum pump.
Control Unit technical data
1. Station maximum power: 175W
2. Safety transformer with mains separator:
230V/24V 50Hz - 120V/24V 60Hz
3. Temperature range: from 100 till 400°C.
4. Programmed temperature accurate: ± 5%.
5. Green LED temperature adjustment optical
control.
6. Abides the CE standards for electrical
security, electromagnetical compatibility and
antistatic protection.
7. Equipotential connector and the tool tip are
connected to station mains ground supply for
ESD protection.
Temperature adjustment for special tips
The temperatures on the dial are set for the
75W desoldering iron with tip 20 DE and for the
50W soldering iron of with tip R-10 D, which
are included in the equipment. A change of tip
or soldering iron model could involve a variation
of ± 7% in the set temperature.
Spare filters
Ref.0781046
Ref.0781184
1
ENGLISH
Desoldering
temperature selection
% Vacuum indicator
and obstruction degree
in the suction circuit
Aspiration inlet