jbc RA 5150 Manual Del Usuario página 6

ENGLISH
- Fit the new tip, and tighten up with the
spanner until the aluminium gasket is
compressed to achieve a good air tightness.
Tip care
- The largest rod that fits in the tip hole should
periodically be passed through in order to
clean the intake tube.
- To clean the tips, use the sponge included
with the stand and check it is slightly
moisted.
Only deionised water (car batter Only deionised water (car batter
Only deionised water (car battery water) Only deionised water (car batter Only deionised water (car batter
should be used in or should be used in order to wet the sponge should be used in or
should be used in or should be used in or
If normal water was to be used, it is very likely
that the tip will become dirty due to the salts
dissolved within the water.
- Do not file the tips or use abrasive tools
which may damage the tip's protective
surface coating and avoid knocking them
about.
- If the tip has been a long time without
being tinned, use the metal brush Ref.
0297705 adaptable to the support, to remove
any dirt and oxid.
IMPORTANT: : : : : DO NOT press the pushbutton
vacuum pump while tinning the desoldering
tip, as the fumes given off by the flux would
quickly soil the ducts and filter of the air
circuit.
y water) y water)
y water) y water)
der to wet the sponge. der to wet the sponge der to wet the sponge
der to wet the sponge
Emptying the desoldering tank and changing
the filter
This should be done while the tip is still hot,
with a minimal temperature of 250°C, to make
sure the tin is melted, and therefore every
precaution should be taken.
- Release the clasp of the lock.
- Pull the lock then you take out the filter,
without spilling any of the solder in the
tank.
- Empty the tank by tipping up the soldering
iron.
- Insert through the tip hole the rod which
matches its diameter.
- Note the state of the filter and replace it if
soiled or damaged.
- Put the lock with the filter again and make
the clasp secure.
4