HoMedics SOUNDSPA PREMIER Manual De Instrucciones E Información De Garantía página 6

Setting and using Alarm 1 and Alarm 2 (Together)
1. Slide the alarm switch to ALARM 1& 2 (Fig. 3) Both ALARM BELL (Fig. 2) icons
will appear on the LCD display.
Note: You can not change the alarm time when ALARM 1& 2 is selected. If
you need to change the alarm time for either alarm follow step 1 under
Setting and Using Alarm 1 or Alarm 2.
2. You may choose one of 3 wake options; BEEP , SOUND, or RADIO by pressing
the ALARM MODE button. A green LED will appear next to the wake mode
selected. (Fig. 4)
NOTE: When using the sound mode, the unit will set to the last sound you
listened to. If you wish to change it press the sound you wish to wake to
(Fig. 5) and then press the POWER button (Fig. 4).
3. When the alarm sounds you may:
a. SNOOZE: Press the SNOOZE button (Fig. 1) Your sleep time will be
extended by 9 minutes. You may use this feature until you turn the
alarm off.
b. RESET: Turn the alarm off by pressing ANY button on the unit, except
for the SNOOZE button (Fig. 4). The alarm clock will automatically
reset for the next day in its current mode. The ALARM BELL icons
and green LED will remain displayed to indicate the alarm is set. If you
wish to change the wake mode follow step 2 under Setting and Using
Alarm 1 and Alarm 2 Together.
c. OFF: To completely turn off the alarm so it is not set for the next day,
slide the alarm switch to OFF.
Note: If one of the Alarm users still needs their alarm set, you will need to
slide the switch on the back of the unit to the alarm that corresponds to
their wake time.
NOTE: If the alarm sounds for 30 minutes continuously it will automatically
turn off.
1 0
Using the Projection Feature
1. To turn the projection feature on, slide the ON/OFF switch (Fig 3) on the back
of the unit to the ON position. The time & outdoor temperature is now projected
on the wall or ceiling.
NOTE: If the projection feature is OFF, you may hit the SNOOZE button
(Fig. 1) to trigger 15 seconds of projection.
2. The angle of the projector can be adjusted to angle on the ceiling or wall
by moving the PROJECTOR TUBE (Fig. 3) forward or backward.
3. To turn the angle of the time & temperature that appears on the wall or
ceiling, rotate the TIME ROTATION KNOB (Fig. 3) until you have reached
your desired result.
NOTE: The TIME ROTATION KNOB will rotate up to 350 degrees.
4. To focus the time & temperature on the wall or ceiling rotate the FOCUS
KNOB (Fig. 3) until you have reached your desired result.
Using Indoor Temperature
The unit will begin reading indoor temperature when it is plugged in. Allow a
few minutes for the correct temperature to register on the LCD display. (Fig. 2)
Using Outdoor Temperature
Be sure the SoundSpa unit is plugged in prior to the remote sensor
battery installation.
1 1