TROUBLE SHOOTING
Indoor and Outdoor temperatures do not match when placed next to
each other -
The sensor is manufactured to be +/- 2 degree in accuracy under normal
conditions. So it is possible to have up to four degrees difference shown on
the separate temperature sensors (one could be "+2 degree" and the other
"-2 degree". Additionally, the calibration curve is different between the two
units because of the greater temperature range of the outdoor sensor. Errors
are usually noted on the extreme ends of the temperature ranges.
SoundSpa unit is not accepting remote transmissions -
The units may not be properly synchronized or the batteries may need to
be replaced. See "USING OUTDOOR TEMPERATURE" section for detailed
instructions. With the two units next to each other, attempt synchronization.
Remember to always place the remote sensor within the effective transmission
range and away from large metal surfaces.
What is the recommended battery type?
We recommend using only alkaline batteries.
Where can I mount the remote sensor?
To get accurate readings and to prolong the life of your sensor, we recommend
that you mount it out of direct sunlight and rain. Fog and mist will not affect the
sensor, but large volumes of soaking rain may. To guard against this, we
recommend that you mount it under the eve of your house, your garage or any
other suitable place that will keep it out of direct sun and rain. Modifications not
authorized by the manufacturer may void users authority to operate this device.
Outdoor Temperature Reading shows "- -"
This may indicate a low battery or out of transmission range.
SPECIFICATIONS
Range of temperature measurement:
º
º
º
Indoor temp : +32
F to +122
F (0
C to + 50
º
º
Remote sensor: -4
F to +140
F (-20
Transmission: max. 100 ft. (30 m) open area, RF434 MHz
º
C)
º
º
C to +60
C)
1 4
FCC DISCLAIMER
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference
that may cause undesired operation.
Freq. 434 MHz
FCC ID: TG3SS-5000TX (Transmitter)
Modifications not authorized by the manufacturer may void users authority
to operate this device.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a resi-
dential installation. This equipment generates, uses and can radiate radio fre-
quency energy and, if not installed and used in accordance with the instruc-
tions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help
N N o o t t e e : : T T h h e e m m a a n n u u f f a a c c t t u u r r e e r r i i s s n n o o t t r r e e s s p p o o n n s s i i b b l l e e f f o o r r a a n n y y r r a a d d i i o o o o r r T T V V i i n n t t e e r r f f e e r r - -
e e n n c c e e c c a a u u s s e e d d b b y y u u n n a a u u t t h h o o r r i i z z e e d d m m o o d d i i f f i i c c a a t t i i o o n n s s t t o o t t h h i i s s e e q q u u i i p p m m e e n n t t . . S S u u c c h h
m m o o d d i i f f i i c c a a t t i i o o n n s s c c o o u u l l d d v v o o i i d d t t h h e e u u s s e e r r s s a a u u t t h h o o r r i i t t y y t t o o o o p p e e r r a a t t e e t t h h e e e e q q u u i i p p m m e e n n t t . .
1 5