Manually Setting Stations Into Memory; Changing The Radio Band Location; Switching To The Monaural Mode - Eclipse CD1000 Manual Del Propietário

Operation
ATTENTION
• Pressing the preset buttons ([1] to [6])
allows you to make one-touch station
selections. The frequency of the selected
station is indicated on the display.
• When a new station is set in memory, the
station previously set in memory will be
deleted.
• If there are fewer than six receivable
stations, the stations set in the remaining
buttons will be retained.
Manually setting stations into
memory
This section covers the setting of stations in
memory under the numbered buttons.
Press the [BAND] button.
1
You can switch the mode to desired
one.
Select a station (see page 17).
Press a button from [1] to [6] for
2
several seconds.
Select any button, from [1] to [6],
3
and press it for more than two
seconds.
The tuned station is now memorized
and set in the selected button.
Repeat the
additional manually tuned stations in
memory, in turn, for the buttons [1] to
[6]. These buttons are called the
preset buttons.
18
procedure to set
Changing the radio band
location
The location for the radio bands used between
the North American region and the Asia/
Australia/Latin region can be switched. The
default setting is USA (North America).
Press the [MODE]
1
several seconds.
The mode will be switched to the
function mode.
Press the [
2
switch the mode selection.
[AREA] will be displayed.
Turn the control dial to select the
3
region.
USA ➔ ASIA
Switching to the monaural
mode
If FM stereo is difficult to receive,switch to the
monaural mode to receive it.
You cannot listen to FM broadcasts in stereo
when the monaural mode is activated.
Press the [BAND] button to switch
1
to the desired FM bands.
2
Press the [FUNC] button.
Press the [2] button while [FUNC]
3
is blinking.
[MONO] appears on the display.
● MEMO ●
• The monaural mode can be
canceled in
procedure.
• [MONO OFF] appears on the
display
button for
] or [ ] button to
➔ AUS ➔ LATIN
the same