Preliminary Checks - SOMFY Home Motion ROLLIXO RTS Manual De Instalación

Ocultar thumbs Ver también para Home Motion ROLLIXO RTS:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Rollixo RTS

1.3 Preliminary checks

> installation environment
attention
Do not spray water onto the motorisation.
Do not install the motorisation in an explosive environment.
> Condition of the door to be motorised
See the safety instructions for the RDO CSI motor.
1.4 electrical pre-equipment
The installation of the power supply must comply with the
standards in force in the country in which the motorisation
is installed, and must be carried out by qualified personnel.
The electric line must be exclusively reserved for the
motorisation and equipped with protection, comprising:
- a 10 A fuse or breaker,
- a differential type device (30 mA).
An all-pole supply cut-off device must be provided.
It is recommended that you fit a lightning conductor
(maximum residual voltage 2 kV).
> Cable feed
Underground cables must be equipped with a protective
sheath with a sufficient diameter to contain the motor cable
and the accessories cables.
For overground cables, use a cable grommet that will
withstand the weight of vehicles (ref. 2400484).
1.5 safety instructions relating to installation
Do not connect the motorisation to a power source before
installation is complete.
Ensure that any danger zones (crushing, cutting, trapping)
between the driven part and the surrounding fixed elements
caused by the opening movement of the driven part are
avoided or indicated on the installation (see the section on
risk prevention).
Modifying one of the elements provided in this kit or using
an additional element not recommended in this manual is
strictly prohibited.
Monitor the door as it moves and keep people away from it
until installation is complete.
Do not use adhesive to secure the motorisation.
attention
Install any fixed control device at a height of less than
1.5 m and within sight of the door, but away from moving
parts.
After installation, ensure that:
- the mechanism is correctly adjusted
- the motorisation changes direction when the door
encounters an object 50 mm high on the ground.
2
DanGer
DanGer
WarninG
WarninG
CAUTION: Automatic door – The door may operate
unexpectedly. Do not leave anything in the door's path.
Permanently affix the label concerning automatic door
operation.
> safety devices
A fall protection device suited to the weight of the door
must be installed to prevent the risk of the door falling.
For operation in automatic mode or remote control,
photoelectric cells must be installed.
For operation by pressing and holding down the button
following a fault with the safety device, the door must be
operated within sight of the door.
For operation in automatic mode, or if the garage door faces
a public road, an orange light type signalling device may be
required to comply with the regulations in the country in
which the motorisation is installed.
> Clothing precautions
Take off any jewellery (bracelet, chain, etc.) during
installation.
For manoeuvring, drilling and welding operations, wear
appropriate protection ( special glasses, gloves, ear
protection, etc.).
1.6 regulations
SOMFY declares that this product complies with the
essential requirements of applicable European directives. A
Declaration of Conformity is available at www.somfy.com/ce
(Rollixo RTS).
1.7 assistance
You may encounter difficulties or have questions when
installing your motorisation.
Do not hesitate to contact us; our specialists are on hand to
answer all your questions.
Internet: www.somfy.com
WarninG
DanGer
WarninG
WarninG
Copyright © 2014 Somfy SAS. All rights reserved.

Publicidad

Tabla de contenido
loading

Tabla de contenido