Installation; Laws, Technical Rules And Norms; Electric Connection; Equipotential - Lotus F10D-64ET Instrucciones Para La Instalación Y El Uso

Installation must be carried out observing the following norms:
- Safety prescription in force
- Installation prescription, ECI norms.
The appliance is supplied without the connection cable.
To install the power supply cable, proceed as follows:
•
Remove the back panel
•
Push the connection cable through the cable blocker, connect the conductor wires to the corresponding terminals in
the junction box and fix them into place.
•
Block the cable with the cable blocker, and reassemble the back panel. The earth wire must be longer than the
others so that if the cable blocker should break, it will disconnect after the tension wires.
N.B. The connection cable must have the following characteristics: it must be at least type H05 RN-F (resistant to a
temperature of at least 150°), and must have an adequate section for the power of the appliance (see technical data
table).
The appliance must be connected to an equipotential system. The connection screw is positioned at the back of the
appliance and is identified by the symbo
Attention! The manufacturer will neither be held responsible for, nor will give any compensation during the guarantee
period for any damage caused, and which is due to inadequate installations not compliant with the instructions.
Before using the appliance for the first frying, it is necessary to clean it carefully, especially the water tub (see
paragraph "cleaning and care").
Check the connection of the appliance and start it up following the instructions.
Use the appliance only under surveillance.
- Oil or fat already used are more at risk of catching fire; therefore only use fresh oil or fat for frying.
- The food to be fried must be dry; damp or wet fry cause froth and danger of overflowing.
- Also large quantities of fry cause froth. It is advisable to fry 1 Kg of food at a time.
- When the oil goes below the minimum level, fire risk is higher.
- Never start up the appliance without oil.
These frying appliances allow to fry potatoes, fish vegetables, etc.
Check that the oil drainage tap inside the opening is closed(horizontal position).Fill the tub with oil up to the level
indicated inside the tub(between min and max).Switch on the switch situated above the appliance. Turn the knob
from"O" into the desired position between 100° and 180°; The white and green lights come on. The green light
indicates the presence of electrical tension. The white light shows that the heating element is working; when the
temperature is reached, it goes out. To turn off the appliance, turn the knob into position "O".
To use the deep fryer with products other than oil (lard, for example) and in any case featuring high thermal inertia, the
thermostat needs to be set at a low value (e.g. 110°C) at the first cycle (starting from cold).
Only after the entire mass has dissolved can the thermostat be set at the maximum level
GB

LAWS, TECHNICAL RULES AND NORMS

ELECTRIC CONNECTION

EQUIPOTENTIAL

.

STARTING UP

INSTRUCTIONS FOR USE

TURNING ON

IE
21