Nuova Simonelli APPIA II V 2GR Manual Del Usuario página 32

At the end of installation, the device
is switched on and taken to rated
operating conditions, leaving it in a
state in which it is "ready for opera-
tion". The device is then switched off
and the whole hydraulic circuit is
bled of the first lot of water in order to
remove any initial impurities. The
device is then refilled and taken to
rated operating conditions.
reaching the "ready for operation"
condition, the following dispensing
operations are carried out:
- 100% of the coffee circuit through the
coffee dispenser (for more than one
dispenser, this is divided equally);
- 100% of the hot water circuit through
the water dispenser (for more than one
dispenser, this is divided equally);
- opening of each steam outlet for 1
minute.
At the end of installation, it is good
practice to draw up a report of the
operations.
The maximum and minimum storage
temperatures must fall within a range
of [-5, +50]°C.
The operating temperature must be
within the range of [+5, +35]°C.
28
Basic rules must be observed when
using any electric appliance.
In particular:
do not touch the appliance when
hands or feet are wet;
do not use the appliance when
CAUTION
RISK OF ELECTRIC SHOCK
barefoot;
do not use extensions in bath or
shower rooms;
do not pull the supply cord out of
the socket to disconnect it from
the mains;
do not leave the appliance
exposed to atmospheric agents
(rain, sun, etc..);
do not let the appliance be used
by children, unauthorised staff or
staff who have not read and fully
understood the contents of this
handbook.
Before servicing the appliance, the
authorised technician must first
switch off the appliance and remove
the plug.
For all cleaning operations comply
exclusively with the instructions
given in this booklet.
If the appliance breaks down or fails
Fig. 5
to work properly, switch it off. Any
intervention is strictly forbidden.
Contact qualified experts only.
Repairs should only be made by the
manufacturer or authorized service
centres. Only original spare parts
must be used. Failure to observe the
above, could make the appliance
unsafe.
Fig. 6
Fig. 7